Yamaha RX-V395 User Manual

28

You can also make use of an automatic preset tuning function for FM stations only. With this function, this unit performs automatic
tuning and stores stations with strong signals sequentially. Up to 40 stations are stored automatically in the same way as in the
manual preset tuning method on page 27.

To tune to higher frequencies, press right side once.
To tune to lower frequencies, press left side once.
* If the TUNING button is not pressed for a while, automatic

preset tuning begins automatically toward higher
frequencies.

Automatic preset tuning begins from the frequency currently
displayed. Received stations are programmed to A1, A2 ...
A8 sequentially.
* If more than 8 stations are received, they are programmed

to the preset station numbers in other groups in
alphabetical order.

If you want to store the first station received by the
automatic preset tuning to a desired preset station
number.
If, for example, you want to store the first received station to
C5, select “C5” by using the A/B/C/D/E button and the preset
station number selector buttons after pressing the MEMORY
button in step 2. Then press the TUNING button. The first
received station is stored to C5, followed by C6, C7, etc. in
sequence.
If stations are stored up to E8, the automatic preset tuning is
automatically concluded.

Press and hold for
more than 3 seconds.

Flashes.

The display shows the frequency of the last preset station.
Check the contents and the number of preset stations by
following the procedure of the section “To recall a preset
station” on page 27.

Follow the procedure in the section “To recall a preset station”
on page 27.
* A recalled station is shown by the frequency in the display.

●

You can replace a preset station with another FM or AM

station manually by following the procedure in the section
“To store stations” on page 27.

●

If the number of received stations is not enough to be stored

up to E8, the search is finished automatically after searching
all frequencies.

●

With this function, only stations with sufficient signal strength

are stored automatically. If the station you want to program
is weak in signal strength, tune to it in monaural manually
and program it by following the procedure in the section “To
store stations” on page 27.