Yamaha UW10 User Manual

Make sure that the hard disk has enough free space. If there is insufficient space, you 
may be unable to record successfully.

1-1 Connect the UW10 to a computer.
1-2 Use an audio cable to connect the UW10’s INPUT jacks to the output jacks 

of the AV device that plays the recording source.

The output jacks on the AV device could be AUX OUT jacks, external output jacks, or a 
headphone jack. If you connect it to the headphone jack, you can raise the recording level.

1-3 Set the UW10’s SOURCE SELECT switch to “INPUT.”

2-1 Start TWEplus on the computer.

The “Browse for Folder” window opens.

2-2 Select a recording destination folder on the hard disk, then click [OK].

You can usually select the default folder.

3-1 From the [File] menu, select [New...].

The “New” window opens.

3-2 Select a file format.

Generally, select “WAVE 44100Hz 16bit stereo” for music CDs. This is the 
default setting.

3-3 Specify a “In Time” value for the “Length” parameter.

Specify the duration that is slightly longer than that of one side of the vinyl 
record or cassette tape you wish to record. For example, if the recording source 
is a 60-minute cassette tape, specify something like “32 min 0 sec 0 msec.”