4XEM stylus c86 User Manual

Page of 40
Requirements and Notices
Important Safety Instructions
Before using your printer, read these safety instructions to make sure you use it safely and 
Be sure to follow all warnings and instructions marked on the printer.
Use only the type of power source indicated on the printer’s label.
Connect all equipment to properly grounded power outlets. Avoid using outlets on 
the same circuit as photocopiers or air control systems that regularly switch on and 
Place the printer near a wall outlet where the plug can be easily unplugged.
Placez l’imprimante près d’une prise de courant où la fiche peut être débranchée 
Do not let the power cord become damaged or frayed. 
If you use an extension cord with the printer, make sure the total ampere rating of the 
devices plugged into the extension cord does not exceed the cord’s ampere rating. 
Also, make sure the total ampere rating of all devices plugged into the wall outlet does 
not exceed the outlet’s ampere rating.
Keep your printer and computer system away from potential sources of 
electromagnetic interference, such as loudspeakers or cordless telephone base units.
Avoid locations that are subject to rapid changes in heat or humidity, shocks or 
vibrations, or dust.
Leave enough room around the printer for sufficient ventilation, leaving at least 
3.9 inches between the back of the printer and the wall.
Do not place the printer near a radiator or heating vent or in direct sunlight.
Place the printer on a flat, stable surface that extends beyond the printer base in all 
directions. The printer will not operate properly if it is tilted or at an angle.
When transporting or storing the printer, don’t tilt it, stand it on its side, or turn it 
upside-down. This may allow ink to leak from the ink cartridges.
Turn off and unplug the printer before cleaning. Clean with a damp cloth only. Do 
not spill liquid on the printer.
Caution: Always turn the printer off using the 
 power button. Don’t switch off the 
power strip or unplug the printer until the green 
 power light is off.
Do not block or cover the openings in the printer’s case or insert objects through the 
Except as specifically explained in this manual, do not attempt to service the printer 
Report Bug