Electro-Voice cpsm eds User Manual

The CPSM shock-mount kit is a permanent

mounting accessory providing shock isola-

tion for the CP212 and CP218 podium mi-

crophones. The amount of isolation is sub-

stantial, in excess of 15 dB at 200 Hz (see

Figure 1). The CPSM is also theft resistant

after installation, with the microphone locked

to the shock mount’s sleeve insert. Mount-

ing a CP212 or CP218 to a podium, lectern

or desk top is quick and easy using the CPSM

shock-mount kit.

The CPSM kit consists of a shock mount,

template, set screw, hex-key wrench and

three screws. It is designed for installation

into panels up to 1

1

/

2

 inches thick.

1.

Select the microphone location by first

checking for obstructions under the panel that

will interfere with the microphone, and for a

flat surface on which to properly seat the top

flange. Panel thickness may not exceed 1

1

/

2

inches (38.1 mm).

2.

Clean the surface of the panel on which

the shock mount is to be installed.

3.

Crack and peel off the protective back-

ing of the template and carefully place the

template on the panel surface at the chosen

location for the shock mount.

4.

Drill a 1

3

/

8

-inch diameter hole (approxi-

mately 39.4 mm) through the center of the

template.

5.

Drill three holes for the #6 wood screws.

The hole size for these screws will depend

on the panel material.

6.

Set the roll-off switch on the microphone

for the desired response.

7.

Insert the microphone into the shock

mount. Turn the microphone so that the plas-

tic roll-off switch holder and the switch do

not come in contact with the set screw. In-

sert the microphone to the top of the

microphone’s electronics housing, as shown

in the photograph. (The top of the electron-

ics housing is the junction just above the

three holding set screws.)

8.

Mount the kit’s set screw on the pro-

vided hex-key wrench. Insert the set screw

into the tapped hole in the steel sleeve and

tighten, securing the microphone in the shock

mount.

9.

Connect the female 3-pin connector to

the microphone. If depth is restricted, a right-

angle audio connector may be required. Place

the shock mount into the drilled hole. Align

the shock mount with the three drilled holes.

Secure the assembly to the panel by screw-

ing in the three remaining wood screws.

The shock mount shall have a minimum of

15 dB of shock isolation at a frequency of

200 Hz in the vertical axis.

Dimensions shall be 2.06 inches (52.32 mm)

diameter and 1.29 inches (32.77 mm) high.

Net weight shall be 1.21 ounces (34.35

grams). The shock mount shall have a non-

reflecting black polycarbonate plastic outer

flange that fits into a hole of 1

3

/

8

 inches (39.4

mm) in diameter and is secured to a desk

top by three screws; two butyl rubber shock

mounts; and a nickel-plated steel inner sleeve

that captures the microphone and acts as a

theft-resistant security device.

The Electro-Voice CPSM shock mount is

specified.

Electro-Voice products are guaranteed

against malfunction due to defects in mate-

rials or workmanship for a specified period,

as noted in the individual product-line

statement(s) below, or in the individual prod-

uct data sheet or owner’s manual, beginning

with the date of original purchase. If such