Electro-Voice precision remote amp User Manual

Menu control for selection of DSP parameters, speaker assign,
impedance monitoring or protocol.

Each block of DSP functions shows the amount of active parameters. 
Filter response, delay times and dynamic settings are displayed as a thumbnail. 
The DSP functions are:

Master-EQ with five filters, each selectable as Low or Hi-Shelf,
Low or Hi-Pass, or PEQ.

Input-Delay for channel A, B and A+B, up to 1,000 ms.
Input-Routing (A, B, or A+B).

Channel-EQ with five filters as master EQ and additional all-pass
filter.

Crossover with Hi and Lo-Pass Filter

First to fourth order (Bessel, Butterworth, Linkwitz-Riley)
compressor and limiter per channel.

Input-Delay for A, B, or sum A+B.
Maximum delay time 1,000 ms. Units:
µs, ms, s, cm, meters, inches, or feet.

Compressor and limiter per output.
Threshold assignable in volts or dBu.

Supervision for each connected loud-
speaker with individual upper and lower
thresholds for impedance values. An out-
of-limit device will show up immediately.

Master EQ with five filters. Display of the
filter response and the acoustical impact
of each filter on the loudspeaker system.

Channel-EQ with five filters.
Display of the filters and their acoustical
impact on the loudspeaker system.

Crossover with each Hi and Lo-Pass per
channel. Impact of all DSP parameters
(filters, delay, level) to acoustical delivery
of the system can be displayed.