Electro-Voice s-40mb eds User Manual

Mounting Bracket Kit

1.

Refer to Figure 1 for the following

steps.

2.

Remove the paper backing from one

of the Friction Pads (C) and attach to the

U-Bracket (A) as shown.  Be sure the two

1/4-inch holes are aligned.  Attach the sec-

ond Friction Pad in a similar manner.

3.

Attach the U-Bracket to the wall us-

ing fasteners that are suitable for the wall

material (not supplied).

4.

Remove the two plastic hole plugs

from each end of the S-40 or S-40T speaker

by gently prying with a small screwdriver.

5.

Place a Nylon Washer (D) on the

threaded stud of each of the Torque Knobs

(B).

6.

Mount the S-40 or S-40T speaker to

the U-Bracket using the Torque Knobs and

Nylon Washers.  Do not tighten.

7.

Rotate the speaker so that the input

panel is accessible and attach the wires to

the input panel.  Position the speaker for

the desired coverage and gently tighten the

Torque Knobs.

1.

Refer to Figure 2 for the following

steps.

2.

Remove the paper backing from one

of the Friction Pads (C) and attach to the

U-Bracket (A) as shown.  Be sure the two

1/4-inch holes are aligned.  Attach the sec-

ond Friction Pad in a similar manner.

3.

Screw the U-Bracket assembly onto

the mic stand using the threaded middle hole

on the U-Bracket.

4.

Snug the mic stand locking nut on the

bottom side of the bracket to prevent it from

moving.

5.

Remove the two plastic hole plugs

from each end of the S-40 speaker by gen-

tly prying with a small screwdriver.

6.

Place a Nylon Washer (D) on the

threaded stud of each of the Torque Knobs

(B).

7.

Mount the S-40 speaker to the U-

Bracket using the Torque Knobs and Nylon

Washers.  Do not tighten.

8.

Rotate the speaker so that the input

panel is accessible and attach the wires to

the input panel.  Position the speaker for the

desired coverage and gently tighten the

Torque Knobs.

Electro-Voice products are guaranteed

against malfunction due to defects in mate-

rials or workmanship for a specified period,

as noted in the individual product-line

statement(s) below, or in the individual prod-

uct data sheet or owner’s manual, beginning

with the date of original purchase. If such

malfunction occurs during the specified pe-

riod, the product will be repaired or replaced

(at our option) without charge. The product

will be returned to the customer prepaid. Ex-

clusions and Limitations: The Limited

Warranty does not apply to: (a) exterior fin-

ish or appearance; (b) certain specific items

A

B

C

D

1

2

2

2

U-Bracket

Torque Knob

Friction Pad

Nylon Washer