Echo PE-230 User Manual

1.  Connect ignition stop leads (A) and (B).

2.  Place throttle linkage (C) through adjustment fixture (D) and install 

wire end into large carburetor throttle swivel hole (E). Check 

throttle for freedom of movement and that wide open throttle / low 

idle extremes are adjusted properly. The throttle linkage must be 

adjusted by moving the adjustment fixture (D). Consult with your 

Echo Dealer for correct adjustment procedure.

3.  Bundle and secure ignition leads against engine housing with clip 

(F).

Tools Required:   Cross-Head Screwdriver

Parts Required:  Front Handle, Lower Bracket, 4 - 5x35 mm screws    

 

 

Label shows minimum spacing for front handle location.

1.  Assemble front handle and bracket loosely to drive shaft.

2.  Position front handle in comfortable operating position and tighten 

screws.