Echo PE-230 User Manual

Tools required:   8 mm Open End Wrench, 4 mm Hex Wrench,  

 

 

 

 

Clean rag

Parts Required:   POWER BLENDX

TM

 8 oz. (P/N 91014) or Lithium    

 

 

 

Base Grease.

1.  Loosen two (2) screws (A) and remove center locating screw (B).   

Pull gear box and shield from drive shaft housing.

2.  Pull flexible cable from the drive shaft housing, wipe clean and  

recoat with a thin coating [15 ml (1/2 oz.)] of grease.

3.  Slide the flexible cable back in the drive housing.  DO NOT get  

dirt on the flex cable.

4.  Install the gear housing and shield assembly.

Tools Required:   T-Wrench, Locking Tool, Needle Nose Pliers, 13 mm   

 

 

 

Open End Wrench

Parts Required:   POWER BLENDX

TM

 8 oz. (P/N 91014) or Lithium    

 

 

 

Base Grease, Blade P/N 69601552632, split pin P/N    

 

 

 

90030020022

Grease gear case every 50 hours of use.  Replace blade when it 

is worn shorter than 6 inches.  Remove blade and holders before 

greasing to prevent damage to gear and bearings.

1.  Shut engine off.

2.  Remove split pin (A).

3.  Rotate blade until holes in inner blade adapter (B) and gear box 

align.  Insert locking tool supplied to lock PTO shaft (C).

nOTE 

Shield cover not shown for illustration clarity.

nOTE  

Blade nut (D) is left hand thread.

4.  Remove blade nut (D) in a clockwise direction using box wrench 

supplied.  Remove outer blade adapter (E), blade (F) and inner 

blade adapter (B).