Echo PB-620H User Manual

Use only ECHO approved attachments. Serious injury may result from the use of a non-approved attachment com-

bination. ECHO, INC. will not be responsible for the failure of cutting devices, attachments or accessories which 

have not been tested and approved by ECHO. Read and comply with all safety instructions listed in this manual and 

safety manual.

•  Check unit for loose/missing nuts, bolts and screws. Tighten and/or replace as needed.                                         

•  Do not use blower if any part is missing or damaged.

•  Have repairs done only by an authorized ECHO Service dealer.

•  Do not use any attachment, accessory or replacement part unless it is recommended in this Operator's Manual.

Moving parts can amputate fingers or cause severe injuries.  Keep hands, clothing and loose objects away from all 

openings.     

• ALWAYS stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop  

before removing obstructions, clearing debris, or servicing unit.

• DO NOT start or operate unit unless all guards and protective covers are properly assembled to unit.

• NEVER reach into any opening while the engine is running.  Moving parts may not be visible through openings.

The 300 hour emission compliance period is the time span selected by the manufacturer certifying the engine emis-

sions output meets applicable emissions regulations, provided that approved maintenance procedures are followed as 

listed in the Maintenance Section of this manual.

Check fuel system for leaks due to fuel tank damage, especially if the unit is dropped. If damage or leaks are found, 

do not use unit, otherwise serious personal injury or property damage may occur. Have unit repaired by an autho-

rized servicing dealer before using.

An Emission Control Label is located on the unit.  (This is an EXAMPLE ONLY, information on label varies by engine 

FAMILY).

The emission control system for the engine is EM/TWC (Engine Modification and 3-way Catalyst) and for the fuel tank 

the Control System is EVAP (Evaporative Emissions) or N (for nylon tank). Evaporative emission may be applicable to 

California models only.