Echo PE-280 User Manual

 

Parts Required:  Power head, Drive Shaft Assembly

1.  Stand power head upright on a level surface.

2.  Loosen the two (2) drive shaft clamp bolts (B) at engine drive shaft 

clamp, and remove center drive shaft location bolt (A).

3.  Remove dust cap and carefully fit drive shaft assembly to engine    

 

making sure that inner drive shaft engages into clutch mount.

4.  Turn drive shaft housing until locating hole lines up with location  

hole in clamp and install center drive shaft location bolt (A).

Gear Housing must be aligned properly with engine.  Aligning cen-

ter locating hole in driveshaft housing with center drive shaft bolt 

(A) provides correct alignment.

The ECHO product you purchased has been factory pre-assembled for your convenience. Due to packaging restrictions, 

some assembly may be necessary.

After opening the carton, check for damage.  Immediately notify your retailer or ECHO Dealer of damaged or missing 

parts.  Use the contents list to check for missing parts.

___ 1,   Power Head

___ 1,   Drive Shaft Assembly

___ 1,   Plastic Bag (Co-Pack)

___ 1,  Operator's Manual

___ 1,  Safety Manual 

___ 1,  Warranty Registration Card

___ 1,   Front Handle

___ 1,   Lower Bracket, Front Handle

___ 4,   5 x 35 mm screws

___ 4,   5 mm nuts*

___ 2,   Split pin

___ 1,  Safety Glasses

___  

Assembly Tool (s)

* 5mm nuts may not be needed.