Epson ActionNote User Manual

The configuration you define through SETUP is stored in a

special area of memory called CMOS RAM. This memory is

backed up by a battery, so it is not erased when you turn off or

reset the computer. Whenever you start the computer it checks

the settings, and if it discovers a difference between the

information in CMOS RAM and your system’s configuration, it

prompts you to run SETUP. You see a message such as the

following:

CMOS memory mismatch

Run SETUP

You also see the following prompt at the bottom of the screen:

Press F1 to continue or Delete to run SETUP

If  this happens,  press              to run SETUP and correct the

setting.

To start SETUP, make sure there is no diskette in the diskette

drive; then turn on your computer. (If your computer is already

on, turn it off, wait 20 seconds, and then turn it on again.) After

the self test, you see the following prompt at the bottom of the

screen:

Press Delete to run SETUP

As  soon  as you see  this message,  press                 

If you do not press               within approximately five seconds,

the computer starts loading the operating system and you will

not be able to run SETUP. If this happens, restart or reset the

computer and try again.