Epson ActionNote User Manual

When you leave the SETUP program, you can choose to either

save the settings you have changed or exit the program without

saving any changes.

Follow these steps:

1. Press                 You  see  the  following  prompt:

PRESS F5 TO 

AND EXIT

PRESS F1 TO EXIT 

2. If you want to save your changes, press                        I f you don’t

want to save your changes, press

  Either way, the

system reboots.

3. If you have just run SETUP for the first time, see “Post-SETUP

Procedures,” below.

You may see an error message and a prompt to run SETUP

when your computer is rebooting if it detects a problem in

your SETUP configuration. If so, follow the instructions on

the screen to run SETUP and correct the problem.

You may also see an error message if you have not installed

your operating system on the hard disk and you have not

inserted a system diskette in drive A. If you receive this error

message, follow the instructions in your operating system

manual to install the software.