Epson Y16499100301 User Manual

you have connected

an external diskette drive to the computer, this switch

determines whether MS-DOS and your application programs

access the drive as drive A or drive B. The external drive

should be drive B, unless you are using a copy-protected

application program that requires the diskette to be loaded in
drive A. In this case, you can assign the external drive as A by
turning switch 2 off. If you want it to be drive B, turn the
switch on.

switch tells the

computer how many diskette drives it has. If you have one

diskette drive, turn this switch on. If you have two drives

(either two internal or one internal and one external) turn it off.

switch tells

the computer whether the built-in serial port is primary or

secondary. If you install the optional modem card, which has

an external serial port, you can use this DIP switch to select

which port is to be primary and which is to be secondary.

If you do not have a modem installed or if you want the built-

in port to be the primary port, turn switch 4 off. If you want

the modem port to be the primary port and the built-in port to

be secondary, turn switch 4 on,

After you complete steps 1 through 6, you’re ready to

turn on the power and start using your Equity LT computer.

But before you turn it on, read the following safety rules.

Follow these rules to avoid accidentally damaging your

computer or injuring yourself:

l

Do not attempt to dismantle any part of the computer. If
there is a hardware problem you cannot solve after reading

Appendix B on troubleshooting or performing the system

diagnostics in Appendix D, consult your Epson dealer.