Epson Y16499100301 User Manual

6. When the copy is completed, you see this message:

Copy another diskette (Y/N)?

Your diskette has now been copied and you can either
make another copy or leave the DISKCOPY command.

Press Y to perform another copy or 

N 

to end the

DISKCOPY command.

Follow the steps below to make a copy of a 360KB diskette

in an external 5   -inch diskette drive. These instructions

assume the external drive is assigned as drive B. If you turned

off DIP switch 2 on the back panel to make the external drive
A, substitute A for B in the instructions.

1. First be sure your original diskette is write-protected.

(There should be a write-protect tab over the write-protect

notch.)

2. Insert the working copy of your MS-DOS system diskette

in drive A (or type C: to log on to drive C if you have a
hard disk).

3. At the A> or C> prompt, type:

DISKCOPY B: B:

and press 

Enter. 

MS-DOS displays these messages:

Insert SOURCE diskette in drive B:

Press any key when ready . . .

4. Insert the diskette you want to copy from in the external

diskette drive (B) and press 

Enter.

DISKCOPY copies the contents of the diskette to the
computer’s memory. Then the screen displays these

messages:

Insert TARGET diskette in drive B:

Press any key when ready . . .

4-11