Sanyo lns-w10 User Manual
28
Talking
Lit steadily (red)
Charging
Lit steadily (green)
Incoming call
Flashes in same pattern as telephone ring (red)
Voice mail
Flashes every 2 seconds (red)
No telephone line
Flashes every 1 seconds (red)
SOUND SIGNALS
A long warbling tone
Signals an incoming call
Single tone
A key is pressed
Two short beeps
Call waiting / MIC mute
One long beep
Confirmation tone / Page signal / Call
back
back
Three short beeps
Error tone / Out of range
Two short beeps every 15 seconds
Low battery warning
TROUBLESHOOTING
TELEPHONE
No dial tone
Check installation:
Is the base unit plugged into the telephone line and AC power source? If
the telephone line is not properly connected to the base unit NO LINE will
appear on the handset display.
the telephone line is not properly connected to the base unit NO LINE will
appear on the handset display.
Is the AC power source turned on at the socket?
Are the batteries properly installed in the handset?
Dial tone is OK, but cannot dial out
Try moving the handset closer to the base unit.
If this doesn’t work, try a different position for the base unit. Typically, the
higher you place the base unit, the better the reception.
higher you place the base unit, the better the reception.
The battery charge level may be low. Check the LCD display for the low
battery-warning signal. If the battery is low, place the handset in the base
unit’s charging cradle to charge.
battery-warning signal. If the battery is low, place the handset in the base
unit’s charging cradle to charge.