Sharp PG-LX3500 User Manual

• Loosen the securing screw from the lamp

unit. Hold the lamp unit and pull it in the

direction of the arrow. At this time, keep

the lamp unit horizontal and do not tilt it.

• Press the lamp unit firmly into the lamp unit

compartment to align the lamp connectors.

Fasten the securing screw.

• Slide the lamp unit cover horizontally back

into place and align the tabs (1). Then

tighten the user service screw (2) to
secure the lamp unit cover.

• If the lamp unit and lamp unit cover

are not correctly installed, the power

will not turn on, even if the power

cord is connected to the projector.

Reset the lamp timer after replacing the lamp. 

• Make sure to reset the lamp timer only when

replacing the lamp. If you reset the lamp timer

and continue to use the same lamp, this may

cause the lamp to become damaged or

explode.

• Plug the power cord into the AC socket of

the projector.

• While simultaneously holding down

MENU, ENTER and

R

on the projector,

press

STANDBY/ON on the projector and

keep all four buttons pressed down until

the lamp indicator starts blinking green.

• “LAMP 0000H” is displayed, indicating

that the lamp timer is reset.

AC socket

ENTER button

MENU button

R

button

STANDBY/ON

button

Securing

screw