Electrolux 241978401 User Manual
11
Removing the Doors
Once both doors are in place, ensure they are aligned
with each other and level (Please see the “Installation”
section for more details), and replace the top hinge
cover.
with each other and level (Please see the “Installation”
section for more details), and replace the top hinge
cover.
CAUTION
Be sure doors are set aside in a secure position
where they cannot fall and cause personal injury,
or damage to the doors or handles.
where they cannot fall and cause personal injury,
or damage to the doors or handles.
NOTE
You will be pulling approximately three (3) feet of
water tube from the back of the refrigerator.
water tube from the back of the refrigerator.
Lower Hinge Removal
4 Unscrew the three (3) lower hinge screws and
hinge if necessary.
To reinstall the right door, reverse the above steps.
Removing Freezer Drawer
1 Open freezer drawer.
2 Remove drawer screws on right and left sides
(two (2) screws on each side).
NOTE
DO NOT remove center screw from freezer drawer.
This is a factory adjustment.
This is a factory adjustment.
3 Lift drawer up and out to remove.
CAUTION
Drawer is heavy. Use caution when lifting.
NOTE
Support door and hold stationary while removing
screws. Factory adjustment may be affected if door is
allowed to fall forward during screw removal.
screws. Factory adjustment may be affected if door is
allowed to fall forward during screw removal.
Installing Freezer Drawer
1 With lower slides and basket pulled out, mount
drawer in reverse of removal.
2 Tighten drawer screws then turn another 1/4 turn.
3 Check gasket seal around freezer drawer. Make
adjustments on drawer screws if necessary.