SMART Technologies board 800i5 User Manual
Network controls
These commands control your projector’s network status and settings. These settings are located in
the OSD, and are available even when the projector is in Standby mode. You must locally set the
network and VGA out commands to on for the network abilities to work.
These commands inform you of the current network settings.
Command
Response
get netstatus
netstatus=connected
netstatus=disconnected
netstatus=disabled
get dhcp
dhcp=[current DHCP status]
get ipaddr
ipaddr=[current IP address]
get subnetmask
subnetmask=[current subnet mask number]
get gateway
gateway=[current network gateway]
get primarydns
primarydns=[current primary domain server]
get macaddr
macaddr=[current MAC address]
These commands control your network settings.
Command
Command target range
Response
set dhcp [target]
=on
=off
dhcp=[current]
set ipaddr [target]
=0.0.0.0 to =255.255.255.255
ipaddr=[current]
set subnetmask [target]
=0.0.0.0 to =255.255.255.255
subnetmask=[current]
set gateway [target]
=0.0.0.0 to =255.255.255.255
gateway=[current]
set primarydns [target]
=0.0.0.0 to =255.255.255.255
primarydns=[current]
A P P E N D I X
B
Remotely managing your system through an RS-232 serial interface
80