Pioneer dvd-v8000 User Manual

Internal Registers 

To activate a function, create a switch contact with an electrical ground (Pin 1).  Check 
Chapter 2 to verify pin (Pin 6 through Pin 13) and terminal (SW1 ~ SW8) assignments. 

 

There are three SW functions in the EXTEND TERMINAL CONTROL. 

1. To recall Command Stacks and execute 

The function, STACK GROUP 1 to STACK GROUP 27, is similar to a combination 
of remote control buttons to recall and execute a stack. 

 

2. To execute the function as a remote control command 

The function acts the same as the buttons (ENTER, PLAY, STOP, etc.) on a remote 
control excluding SCAN FWD/REV. 

DVD-V8000 continues execute SCAN FWD/REV even when the button on the 
remote control is released. But in case of EXTEND TERMINAL CONTROL, it stops 
to execute SCAN FWD/REV when button is released. 
(In case of remote control “releasing SCAN button” will not discontinue the SCAN.  
But  in  case  of  EXTEND  TERMINAL,  releasing  SCAN  switch  will  terminate  SCAN 
operation.) 

 

3. To execute as an advanced remote control button 

Advanced remote control commands such as numbers from 10 to 20 may be sent 
as a switch control command. 

 

Note for additional assistance, please refer to Product Information Bulletin (PIB) 152601 
DVD-V7400 and Jama Port Control available on the Pioneer Electronics website under 
Service & Support – Business Solutions Products. 

 

 

- 82