Simplicity Manufacturing 5900608 zt18441khc User Manual
FastCut Hydro Drive ZTR
7/2005
3
TP 300-7237-IR-HZ-N
Quick Setup List -
Page
Setup Procedure
Steps to Perform
4
Uncrating
❏ Remove crate & banding.
❏ Place transmissions in PUSH position & roll off skid.
❏ Place transmissions in PUSH position & roll off skid.
4
Battery Activation &
❏ Charge the battery
(Note: proceed with other setup steps
Installation
while battery is charging).
❏ Test battery with hydrometer or load-tester.
❏ Install & secure battery.
❏ Install & secure battery.
5
Rider Assembly
❏ Install the seat and connect the seat switch
❏ Install ground speed control levers.
❏ Install ground speed control levers.
6
Check Fluid Levels
❏ Fill & check Engine oil level.
❏ Check transmission fluid level.
❏ Reduce & check tire pressures
❏ Check transmission fluid level.
❏ Reduce & check tire pressures
(Front tires 40 psi, rear tires 15 psi).
7
Mower Assembly
❏ Torque mower blade bolts.
7
Lubrication
❏ Lubricate all grease & oil points.
8
SAFETY CHECKS
❏ Check for LOOSE HARDWARE.
❏ Check all OPERATOR CONTROLS.
❏ Test PARKING BRAKE.
❏ Perform MOWER BLADE STOPPING CHECK.
❏ Check all OPERATOR CONTROLS.
❏ Test PARKING BRAKE.
❏ Perform MOWER BLADE STOPPING CHECK.
(Blade must stop within 5 seconds!)
❏ Perform SAFETY INTERLOCK SYSTEM CHECK.
8
Burnish Electric Clutch
❏ Burnish electric clutch
(run for 15 seconds, repeat 10 times)
.
❏ Repeat MOWER BLADE STOPPING CHECK.
(Blade must stop within 5 seconds!)