Spin Master gyro force User Manual

INSTALLING BATTERIES IN THE GYRO FORCE™

1 -

2 -

3 -

STORAGE: The Gyro Force™ should be 
stored indoors in the foam tray enclosed in 
the box after each use.

Before taking Gyro Force™ back to the 
retailer, call our friendly RC technicians at: 
1-800-622-8339.

Gyro Force™ requires one 9.6-V rechargeable and one 9-V battery to run (Included). 

Locate the battery 
door on the bottom 
of the vehicle. 

Unscrew to release 
the battery door as 
shown.

4 -

5 -

Connect the battery 
wire to the car wire 
as shown. 

Replace the battery 
door and tighten the 
screw back into 
place. 

Place the batteries 
in the tray according 
to the polarity 
markings as shown.

1 -

2 -

3 -

Using a Phillips 
screwdriver, undo the 
hold-down screw and 
remove the battery 
compartment door. 

Place the 9-V
battery in the battery 
compartment, making 
sure to follow the 
correct + and - polarity 
markings. 

Replace the battery 
compartment door
and refasten the 
hold-down screw. 

1 -

2 -

3 -

Turn the “ON-OFF” 
switch to the “ON” 
position. 

Use Controller 
to move vehicle 
forwards or 
backwards.

The vehicle steers like a 
skateboard. By positioning either 
right or left, the vehicle will turn 
right and then left/left and then 
right. To steer, release the turn 
button once the vehicle is pointing 
in the direction desired. 

Note: If you press right or left while holding the Turbo 
button, Gyro Force™ will roll over and perform stunts.

GYRO FORCE™

Battery

Compartment

Door

Battery

Compartment

Door

Battery

Compartment Door

Turn

Vehicle

Over

9.6-V

Battery

9-V

Battery

Battery

Compartment

Battery

Compartment