Epson StylusPro10000 User Manual

4. Push the side pin toward the back while pushing the front half of the 

paper cutter cover down to close the casing. Then release the side pin. 
CLOSE LOWER COVER 

appears on the display.

5. Close the lower cover. The cutter holder moves to the home (far right) 

position and READY appears on the display.

To keep your printer working at its best, you should clean it thoroughly 
several times a year.

1. Make sure the printer is turned off and all the lights on the control panel 

are off. Then unplug the power cord and disconnect the printer from 
the computer.

2. Open the roll paper cover and remove the roll paper spindles. Remove 

any sheet media from the printer. Then use a soft brush to carefully 
clean away any dust or dirt.

3. Close the roll paper cover.

4. Open the lower cover and use a soft brush to carefully clean away any 

dust or dirt inside the lower cover. Then close the cover.

5. Remove the paper hammock. Then clean away any dust or dirt around 

the leg assembly using a soft brush.

Be careful not to touch 
the gears inside the 
printer.

To avoid damaging the 
components as well as 
the case, never use 
alcohol or thinners to 
clean the printer. 

Be careful not to get 
water on the printer 
mechanism or electronic 
components.

Don’t use a hard or 
abrasive brush.

Don’t spray the inside 
of the printer with 
lubricants; unsuitable 
oils can damage the 
mechanism. Contact your 
dealer or a qualified 
servicer if your printer 
needs lubrication.