Epson StylusPro10000 User Manual

8. Push the paper set lever all the way in, then close the lower cover. 

PRESS PAUSE BUTTON 

appears on the control panel display.

9. Press the Pause button. The print head moves and the board feeds into 

printing position automatically. READY appears on the control panel. 
(Even if you don’t press Pause, the board and printer will move into 
printing position automatically after 10 seconds.)

10. Run your print job. After it is finished, the posterboard stays in the 

printer.

11. To remove the print, hold it and pull the paper set lever all the way out.

When you print on heavy stock, you may need to adjust the platen gap 
setting. Normally, the AUTO setting allows the printer to adjust 
automatically. However, if print quality is not satisfactory when you use 
heavy stock, change this setting to WIDE. Follow these steps:

1. Press the SelecType button. PRINTER SETTING MENU appears on 

the display.

2. Press the Item button. PLATEN GAP=AUTO appears on the display.

3. Press the + button. PLATEN GAP=WIDE appears on the display.

To avoid damaging the 
printer, never move the 
paper set lever while the 
Operate or Pause light 
is flashing.