Epson perfection photo 1670 User Manual

EPSON Perfection 1670 Photo

6/03

EPSON Perfection 1670 Photo - 5

The scanner cover has a built-in transparency unit. To scan 
negative film or slides, you need to remove the reflective 
document mat from the cover and place the film in a holder on 
the scanner glass.

1. Make sure the transparency unit cable is connected to the 

back of the scanner.

2. Lift the scanner cover all the way up and slide the reflective 

document mat up and off the scanner cover.

3. Slide the negative strip 

into the film holder 
with the film’s shiny 
base side facing down.

4. Place the film holder in the correct position for your film 

type. If you are scanning slides, place the holder on the 
scanner first, then place the slides in the holder.

Be sure to match the letter on the film holder tab with the 
corresponding letter on the scanner.

Make sure the narrow calibration window at the top of the 
film holder is clean and uncovered to ensure an accurate 
scan.

5. Close the scanner cover.

Make sure there is no dust on the slides or negatives. 
You can select the 

 Dust Removal 

setting in EPSON Scan to improve your scan.

If your scanned image is upside down, you can use 
the 

 Rotate buttons in EPSON Smart Panel 

(not available in all Smart Panel applications) or in 

 

Preview mode in EPSON Scan. You can also rotate 
the image in most image editing applications.

Negatives: 

(A) If you are scanning 
the first 3 frames of 
the negative strip, 
place the film holder 
against the left edge 
of the scanner.

(B) For the last 3 
frames, rotate the 
position of the film 
holder and place it 
against the right edge 
of the scanner.

Slides (C) 
Place the holder on the 
scanner glass, then put 
the slides in the holder.

A 

B 

C