Avocent LongView Wireless Installer User Manual

 

 

Chapter 3: Operations 

The LongView Wireless units (transmitter and receiver) have been factory 

configured to operate as a companion pair. The initial radio link between 

the two units is established by the receiver, although all other aspects of the 

link are controlled by the transmitter. Once the radio link is established, 

mouse, keyboard, video and audio data is free to flow between the two units. 

1.  Complete all of the installation steps. See Chapter 2.

2. Power 

up the LongView Wireless transmitter and wait for the middle 

LED marked as S2 to illuminate.

3. Power 

up the monitor attached to the LongView Wireless receiver.

4. Power 

up the LongView Wireless receiver.

5. Power 

up your computer.

NOTE: Always power up the LongView Wireless transmitter and wait for the middle LED 
marked S2 to illuminate before powering up your computer. 

When the LongView Wireless receiver is powered up, it will display a 

message on the computer monitor to which it is attached:

The 000c4116bc7b is replaced by the MAC id of the radio board in your 

transmitter unit. This message indicates that your receiver unit is actively 

searching for its companion transmitter. When it finds the companion 

transmitter, it will display a second message beneath the first:

The 000c4116bc7b is replaced by the MAC id of the radio board in your 

transmitter unit. This message indicates that your receiver unit is 

establishing the radio link with your transmitter unit. When this link is 

established, both messages will be removed and the monitor will display 

video information from your computer.