Alliance Laundry Systems D677I User Manual
Installation
37
510969
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Make-Up Air Requirements
It is important that the laundry room has adequate
make-up air for the dryer(s). A dryer exhausts 220 cfm
(measured at back of the dryer) and sufficient make-up
air must be supplied to replace the air exhausted by the
dryer.
make-up air for the dryer(s). A dryer exhausts 220 cfm
(measured at back of the dryer) and sufficient make-up
air must be supplied to replace the air exhausted by the
dryer.
Make-Up Air Dos and Don’ts
Do
●
Supply adequate air for ventilating air, drying air
and gas dryer combustion air.
and gas dryer combustion air.
NOTE: Each-dryer pocket must have 40 square
inches (260 cm
inches (260 cm
2
) of unobstructed flow of make-up
air for proper operation.
●
Energy efficient buildings with low air
infiltration rates should be equipped with an air
exchanger that can accommodate on demand
make-up air needs in the laundry room. These
devices can be obtained through your building
contractor or building material suppliers.
infiltration rates should be equipped with an air
exchanger that can accommodate on demand
make-up air needs in the laundry room. These
devices can be obtained through your building
contractor or building material suppliers.
Don’t
●
Draw make-up air from a room containing a gas
fired water heater.
fired water heater.
●
Draw make-up air from a room containing a dry
cleaner or a hair salon.
cleaner or a hair salon.
Exhaust Direction
The dryer can be exhausted to the outdoors through the
back, left, right or bottom of the dryer. EXCEPTION:
Gas dryers cannot be vented out the left side
because of the burner housing.
back, left, right or bottom of the dryer. EXCEPTION:
Gas dryers cannot be vented out the left side
because of the burner housing.
Dryer is shipped from factory ready for rear exhaust;
no kits required.
no kits required.
Exhausting the dryer through sides or bottom can be
accomplished by installing a DK1 Sales Accessory
(Directional Exhaust Kit 528P3) available as optional
equipment at extra cost.
accomplished by installing a DK1 Sales Accessory
(Directional Exhaust Kit 528P3) available as optional
equipment at extra cost.
Figure 27
D361I
D361I
528P3 DIRECTIONAL EXHAUST KIT