Epson C8230 User Manual

Note

• The printer will assume a setting of 1,200 BPS for

switch combinations other than those shown above.

• Since the maximum transmission speed (baud rate)

depends on your type of printer, refer to your

printer’s manual for details.

The jumper is a small terminal used for connecting or
disconnecting a circuit. The jumper is on when the

jumper plug covers both wires of the terminal. Jumper
settings can be changed by either attaching or removing
the rectangular jumper plug. If the jumper is to be
turned off, connect it to just one of the two terminal

pins as shown in the figure below. By doing this, you

can avoid losing the unused jumper plug.

10