Epson C8230 User Manual
DIP switch and jumper settings
Before you install the C82305 * /C82306 * interface, you may
need to adjust the DIP switch 2 and jumper settings.
You can change the DIP switch 1 settings after you
need to adjust the DIP switch 2 and jumper settings.
You can change the DIP switch 1 settings after you
install the interface. When making DIP switch setting
changes, it is best to use a pointed device, such as a
changes, it is best to use a pointed device, such as a
ball-point pen or small screwdriver.
Caution
All changes of DIP switch and jumper settings should be
made with the printer power turned off. New settings
become valid only when the printer is turned on.
made with the printer power turned off. New settings
become valid only when the printer is turned on.
DIP switches
The settings on DIP switches allow you to change
interface functions. The two sets of DIP switches on the
C82305 * /C82306* are labelled SW1 and SW2. Each set
contains a number of individual toggle-type switches
that can be set either on or off. The individual switches are
referred to by set (SW1 or SW2) and number. Therefore,
the switch in set SW1 marked by the small number 3 is
called DIP switchl-3.
contains a number of individual toggle-type switches
that can be set either on or off. The individual switches are
referred to by set (SW1 or SW2) and number. Therefore,
the switch in set SW1 marked by the small number 3 is
called DIP switchl-3.
5