Edelbrock victor jr. 70015 User Manual
Catalog #70014 & 70015
Brochure # 63-0181
©2008 Edelbrock Corporation
Rev. 6/08
Rev. 6/08
Page 1 of 2
Component Installation
1.
Install your new Victor Jr. Nitrous Plate (Item A) onto the carburetor pad using the 4 supplied Carburetor Studs (Item B) and 2
supplied Gaskets (Item C).
supplied Gaskets (Item C).
2.
Install the correct jets (Item D), selected from the chart below, into their corresponding jet holders on the plate. Be sure you
install the selected fuel jet into the fuel fitting and the correct nitrous jet into the nitrous fitting. Failure to install
the jets correctly may result in catastrophic engine damage.
install the selected fuel jet into the fuel fitting and the correct nitrous jet into the nitrous fitting. Failure to install
the jets correctly may result in catastrophic engine damage.
3.
Install the 4AN x 1/8”NPT Tee’s (Item E) into the outlet port of your solenoids using Teflon Paste. Be sure to use the red fittings
for the fuel solenoids and blue fittings for the nitrous solenoids to make line identification easier for future tuning or use.
for the fuel solenoids and blue fittings for the nitrous solenoids to make line identification easier for future tuning or use.
4.
Install the Blue Nitrous Lines (Item F) from the nitrous jet holders to the blue outlet tee from the solenoid. Repeat this step for
the Red Fuel Lines.
the Red Fuel Lines.
Victor Jr. Plate Kits
Catalog #70014 & 70015
INSTALLATION INSTRUCTIONS
Please study all instructions carefully before you install your new Victor Jr. Plate Kit. If you have any questions, please call our
Technical Hotline at: 1-800-416-8628, 7:00 a.m. to 5:00 p.m., Monday through Friday, Pacific Standard Time or e-mail us at
edelbrock@edelbrock.com.
Technical Hotline at: 1-800-416-8628, 7:00 a.m. to 5:00 p.m., Monday through Friday, Pacific Standard Time or e-mail us at
edelbrock@edelbrock.com.
DESCRIPTION:
This kit is an upgrade to your existing system or a replacement for your current plate system. Some additional
components may be required for a complete installation. You must currently have 2 nitrous solenoids and 2 fuel solenoids of the
same style for this system to operate correctly. You also must currently have the bottle, feed lines, solenoid inlet fittings, and any
other components that may be required for a complete system. The Victor Jr. Nitrous Plate was dyno tested and proven using
only Edelbrock components. The dyno testing and jet map are based upon using 2 Performer RPM nitrous solenoids, 2 Performer
RPM Fuel Solenoids, -6AN feed line, and -6AN lines from the feed line to the solenoid inlets. Any variations from this configuration
may change the jet map curve. Tune your nitrous system accordingly.
same style for this system to operate correctly. You also must currently have the bottle, feed lines, solenoid inlet fittings, and any
other components that may be required for a complete system. The Victor Jr. Nitrous Plate was dyno tested and proven using
only Edelbrock components. The dyno testing and jet map are based upon using 2 Performer RPM nitrous solenoids, 2 Performer
RPM Fuel Solenoids, -6AN feed line, and -6AN lines from the feed line to the solenoid inlets. Any variations from this configuration
may change the jet map curve. Tune your nitrous system accordingly.
A
B
C
D
E
F
IMPORTANT NOTE:
Proper installation is the responsibility of the installer. Improper installation will void warranty and may result in
poor performance and engine or vehicle damage.