Sanyo dp42410 User Manual
29
English
Output terminals
Digital Audio Output
Audio Output
1
1
CONFIGURATIONS OF VGA TERMINALS
VGA IN (D-SUB) TERMINAL
Terminal : D-SUB15 PIN
Connect video output terminal of LCD TV to this terminal with a VGA Cable (not supplied). When connecting
Macintosh computer, the MAC Adapter (not supplied) is required.
Terminal : D-SUB15 PIN
Connect video output terminal of LCD TV to this terminal with a VGA Cable (not supplied). When connecting
Macintosh computer, the MAC Adapter (not supplied) is required.
1
Red Input
9
+5V
2
Green Input
10
NC
3
Blue Input
11
Sense 0
4
Reserved
12
DDC_SDA
5
Reserved
13
Horiz. sync.
6
GND
14
Vert. sync.
7
GND
15
DDC_SCL
8
GND
PC / HDMI SIGNAL MODES
This LCD TV can correspond to the signals below. After connecting with the computer, the TV can automatically
recognize the signal from the connected PC (computer) / HDMI.
PC SIGNAL MODE COLUMN (recommended)®
recognize the signal from the connected PC (computer) / HDMI.
PC SIGNAL MODE COLUMN (recommended)®
SYSTEM MODE
Resolution
V-Freq.(Hz)
H-Freq.(KHz)
PIXELS CLOCK (MHz)
VGA
640x480
59.94
31.47
25.18
SVGA
800x600
60
37.88
40
XGA
1024x768
60
48.36
65
WXGA
1360x768
60
47.712
85.5
WXGA
1280x768
60
47.78
79.5
SXGA
1280x1024
60
63.981
108
NOTE:
Ŷ
In principle, the TV can not display signal modes not described in the above column. However, it can sometimes
display a signal very similar with one of the modes described.
display a signal very similar with one of the modes described.
Ŷ
It is not the trouble of the TV if interference appears on the picture while switching the signal mode.
Ŷ
The Dot Clock of the computer’s signal must be less than 108 MHz.
Ŷ
When the input signal from PC is out of the PC signal mode column, above, “No Support” caution message will
display. But in some case, the LCD TV will still display the PC signal though the signal mode doesn’t exist on the
list above. Under this condition, the display position may not correct and the quality may not be admitted also.
display. But in some case, the LCD TV will still display the PC signal though the signal mode doesn’t exist on the
list above. Under this condition, the display position may not correct and the quality may not be admitted also.
When input signal is digital from HDMI terminal, refer to the chart below.
SYSTEM MODE
Resolution
V-Freq.(Hz)
H-Freq.(KHz)
PIXELS CLOCK (MHz)
480I
720(1440)x480
59.94
15.73
27
480P
720x480
59.94
31.47
27
720P/60
1280x720
60
45
74.25
1080I/60
1920x1080
60
33.75
74.25
1080P/24
1920x1080
24
27
74.25
1080P/60
1920x1080
60
67.5
148.5