NEC express5800-100 series n8100-1635f User Manual
7-34 Troubleshooting
MAINTENANCE TOOLS
The Maintenance Tools is used for preventive maintenance, fault analysis, and several settings.
IMPORTANT: This guide contains procedures to use a floppy disk,
however, your modular server is not equipped with factory-installed
floppy disk drive and optical disk drive. Use the optional Flash FDD or
USB FDD.
however, your modular server is not equipped with factory-installed
floppy disk drive and optical disk drive. Use the optional Flash FDD or
USB FDD.
Starting Maintenance Tools
Run the Maintenance Tools according to the following procedure.
1.
Turn on peripheral devices and the modular server in this order.
2.
Insert the NEC EXPRESSBUILDER DVD supplied with your modular server into the
optical disk drive.
optical disk drive.
3.
Press Ctrl, Alt, and Delete to reboot the modular server from the NEC
EXPRESSBUILDER. (You may also turn off and then on again to reboot the modular
server.)
EXPRESSBUILDER. (You may also turn off and then on again to reboot the modular
server.)
System boots up displaying Boot selection menu.
IMPORTANT:
An initial selection of the menu is "Os installation". If
any other menu is not selected, "Os installation" starts automatically 10
seconds after the Boot selection menu is displayed.
seconds after the Boot selection menu is displayed.
Tool menu (Normal
mode): Select this menu
to use the tool on the
local console.
mode): Select this menu
to use the tool on the
local console.
Tool menu (Redirection
mode): Select this menu to
use the tool from the
remote console.
mode): Select this menu to
use the tool from the
remote console.