Bosch fw5 User Manual

Camera Browser Interface

Encoder Settings | en

Bosch Security Systems

Software manual

AM18-Q0605 | v5.0 | 2011.07

If required, enter a new name for the profile.

To optimize use of the bandwidth in the network, limit the data 

rate for the camera. The target data rate should be set 

according to the desired picture quality for typical scenes with 

no excessive motion.

For complex images or frequent changes of image content due 

to frequent movements, this limit can temporarily be exceeded 

up to the value entered in the Maximum bit rate field.

This maximum data rate is not exceeded under any 

circumstances. Depending on the video quality settings for the 

I-frames and P-frames, this can result in individual images being 

skipped.

The value entered here must be at least 10% higher than the 

value entered in the Target bit rate field. If the value entered 

here is too low, it is automatically adjusted.

The Encoding interval slider determines the interval at which 

images are encoded and transmitted. This can be particularly 

advantageous with low bandwidths. The image rate in ips 

(images per second) is displayed next to the slider.

Select the desired resolution for the standard definition video 

image. The following resolutions are available:

–

352 × 240 pixels (displayed as 432 x 240)

–

704 × 480 pixels (displayed as 854 x 480)

These resolutions are not used by a HD stream.