Bosch fw5 User Manual

en | Network

Camera Browser Interface

AM18-Q0605 | v5.0 | 2011.07

Software manual

Bosch Security Systems

To limit connections to SSL encryption, set the Off option in 

the HTTP browser port, the RCP+ port, and Telnet support. This 

deactivates all unencrypted connections allowing connections 

on the HTTPS port only.

Configure and activate encryption for media data (video, audio, 

metadata) on the Encryption page.

Activating RCP+ port 1756 allows unencrypted connections on 

this port. To allow only encrypted connections, set the Off 

option to deactivate the port.

Activating Telenet support allows unencrypted connections on 

this port. To allow only encrypted connections, set the Off 

option to deactivate telnet support, making telnet connections 

impossible.

If necessary, select the Ethernet link type for interface ETH. 

Depending on the device connected, it may be necessary to 

select a special operation type.

Set the maximum segment size for the IP packet's user data 

here. This gives the option to adjust the size of the data packets 

to the network environment and to optimize data transmission. 

Please comply with the MTU value of 1,514 bytes in UDP mode.

Specify a higher MSS value for a connection to the iSCSI 

system than for the other data traffic via the network. The 

potential value depends on the network structure. A higher 

value is only useful if the iSCSI system is located in the same 

subnet as the camera.