Tascam CD-160MK User Manual

If you have problems with your system, look through this 
chart and see if you can solve the problem yourself before 
calling your dealer or TEAC service center.

e Check the connection to the AC power supply. Check 
and make sure the AC source is not a switched outlet and 
that, if it is, the switch is turned on. Make sure there is 
power to the AC outlet by plugging another item such as a 
lamp or fan into the outlet.

e Press the POWER switch of the main unit to turn it on.

e If the batteries are dead, change the batteries.

e Use remote control unit within the range (5 m) and point 
at the front panel.

e Clear obstacles between the remote control unit and the 
main unit.

e If a strong light is near the unit, turn it off.

e Check the connection to the amplifier.

e Check the operation of the amplifier.

e Load a disc with the playback side facing down.

e If the disc is dirty, clean the surface of the disc.

e A blank disc has been loaded. Load a prerecorded disc.

e Depending on the disc, etc. it may not be possible to 
play back CD-R/RW discs. Try again with another disc.

e You cannot play back unfinalized CD-R/RW discs. 
Finalize such a disc in a CD recorder and try again.

e Place the unit on a stable place to avoid vibration and shock.

e If the disc is dirty, clean the surface of the disc.

e Don’t use scratched, damaged or warped discs.

If the surface of the unit gets dirty, wipe with a soft cloth 
or use diluted mild liquid soap. Never spray liquid directly 
on this unit. Apply your cleaner to your cleaning cloth and 
wipe gently. Be sure to remove any excess completely. Do 
not use thinner, benzene or alcohol as they may damage 
the surface of the unit. Allow the surface of the unit to dry 
completely before using.