Telex audiocom bp-2002 User Manual

Introduction     3

The numbers refer to the callouts in Figure 1.

Volume Control - 

Use this control to adjust the headset listen level.

Chan Button and 
Indicators - 

The Chan button (only on the BP-2002) allows the 
user to select which intercom channel is active. Press 
the Chan button to change the channel selection. The 
yellow indicator next to the channel number lights to 
show the active channel.

Call Button and Indicator - 

The Call function allow the user to send or receive 
signals to other devices on the intercom channel 
selected. The call button operates in two ways:

Call Receive: When there is an incoming call 
signal, the indicator is red. (If Audible Call Alert 
is enabled, incoming calls will cause beeps in 
the headset.) ON the BP-2002, call can be sent 
on the selected channel only.

Call Send: To send a call signal to all stations on 
a channel, press and hold the Call button until a 
verbal response is received. The indicator will 
glow red. On the BP-2002, calls can be sent on 
the selected channel only.

Talk Button and 
Indicator - 

The Talk button activates the headset microphone and 
operates in two ways:

Latched Mode: Tap the button once to talk. The 
indicator will glow green. Tap the button again 
when finished with a conversation.

Momentary Mode: Press and hold the button to 
talk momentarily. Release the button when 
finished talking.

On the BP-2002, if no headset is connected, when the Talk button is 

pressed, the Talk button will have the same function as the Chan button.