Atdec TH-1040-VFM User Manual
Back of Display
Mounting Screws (x4)
Washers (x4)
VESA Plate
Choose appropriate Mounting Screws and
Washers from the Hardware supplied
Washers from the Hardware supplied
to suit your Display.
Installation Complete
Step 5. Attaching your Display to the Arm
No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent Atdec Pty Ltd.
Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published 30 .10.11 ©
Step 4. Attaching the VESA Plate to your Display
Step 6. Cable Management
Washer
Mounting Screw
Recessed Mounting
Holes or Display with a
Curved Rear Panel
If the Mounting Holes are
recessed into the back of the
Display, or the Display has a
curved rear panel, use the
appropriated Spacer Bushes
supplied to pack the
Mounting Holes.
Note: Ensure the VESA
plate is securely fixed
to the display.
Holes or Display with a
Curved Rear Panel
If the Mounting Holes are
recessed into the back of the
Display, or the Display has a
curved rear panel, use the
appropriated Spacer Bushes
supplied to pack the
Mounting Holes.
Note: Ensure the VESA
plate is securely fixed
to the display.
VESA Plate
VESA Ball Mount
Ball Mount.
Insert the Security Screw, and tighten using the
Phillips-head Screwdriver.
Phillips-head Screwdriver.
TIGHTEN
Security Screw
Cable Cover
Connect cables to your Display, and route along the arms.
Re-attach the Cable Covers to hold the Cables in place.
Re-attach the Cable Covers to hold the Cables in place.
LOOSEN (-kg)
TIGHTEN (+kg)
Rotate the Display as desired, locking the
Display into position by tightening the
Tension Plate.
Display into position by tightening the
Tension Plate.
+/- 20°
angular tilt
360° infinite
horizontal rotation
Display
Top of
Mounting Hole
Spacer
Hook the top of the VESA Plate onto the VESA
HOOK
Press and hold the Release Buttons. Gently push
bottom of VESA Plate into VESA Ball Mount.
Release Buttons to lock in place.
Release Buttons to lock in place.
PUSH
Release Button
Phillips-head Screwdriver
3mm Allen Key
Tension Plate
Position your Display to the desired viewing angle using the 40°
angular movement allowed by the VESA Ball Mount.
angular movement allowed by the VESA Ball Mount.
If the display does not hold its position, or is too
resistant, adjust the Tension Plate located at the
rear of the VESA Ball Mount.
resistant, adjust the Tension Plate located at the
rear of the VESA Ball Mount.
To make any adjustments, use the 3mm Allen Key
supplied. Apply half a turn at a time to each screw
on the Tension Plate to adjust evenly.
supplied. Apply half a turn at a time to each screw
on the Tension Plate to adjust evenly.
Check the display, and then adjust again if necessary.
Remove the Cable Covers as required using a Phillips-head
Screwdriver.
Screwdriver.
TI P : Leave enough slack in the cables
to allow full movement at the joints.
to allow full movement at the joints.
Step 7. Final Adjustment