Edelbrock 5716 User Manual

©2007 Edelbrock Corporation
Catalog #5716

Brochure No. 63-5716

Rev. 8/07 - DA/mc

Page 1 of 2

Please study these instructions carefully before installing your new Edelbrock Cat-Back Exhaust System. If you have any
questions, please contact our Technical Hotline at: 1-800-416-8628 , 7am - 5pm, Monday-Friday, Pacific Standard
Time or e-mail us at Edelbrock@Edelbrock.com.

❑ 3/8" ratchet and metric sockets

❑ 9/16” and 15mm Wrench

❑ Jack and jackstands

❑ Liquid penetrant and rubber lubricant

1. Raise and support vehicle.

2. Remove the V-clamp behind the muffler and remove

the rear portion of the exhaust.

3. Unbolt the two flanges on the inlet pipes and remove

the muffler section of the exhaust. NOTE: You will
need to re-use the original gaskets and bolts on new
system.

1. Using the original gaskets and bolts, install new inlet

pipes and place hangers in the rubber isolators. Left
inlet pipe #25-3287, right inlet pipe #25-3288.

2. Slip muffler onto the inlet pipes using two 2-1/2”

band clamps. NOTE: Inlet end of muffler is marked.
Snug the clamps so you can adjust system later.

3. Install overaxle pipe #25-3289 using a 3” band

clamp and placing the hangers in the rubber
siolators. snug the clamp so you can adjust system
later.

4. Install polished tailpipe #25-3157 using a 3” band

clamp. Snug the clamp so you can adjust system
later.

❑ 1

25-3287

Left Inlet Pipe

❑ 1

25-3288

Right Inlet Pipe

❑ 1

25-3289

Overaxle Pipe 

❑ 1

25-3157

Tailpipe (Polished)

❑ 1

22-5716

Installation Kit

5. Working from the front of the ysstem to the rear,

adjust, align, and tighten all the band clamps. Give
adequate clearance for fuel lines, brake lines,
electrical wiring, and the spare tire.