Epson EMP-821 User Manual
74
Maintaining and Transporting the Projector
6. Hold the lamp as shown and pull it straight out.
7. Gently insert the new lamp. If it doesn’t fit easily, make sure it’s
facing the correct way.
8. Once the lamp is fully inserted, tighten its screws.
9. Lower the lamp cover into place. (The opening should be almost
covered, and the top of the cover should be flush with the top of
the projector.) Then slide the cover closed and tighten the screw.
the projector.) Then slide the cover closed and tighten the screw.
10. Reset the lamp timer as described in the next section.
warning
This product includes a lamp
component that contains
mercury (Hg). Please consult
your state and local
regulations regarding disposal
or recycling. Do not put it
in the trash.
component that contains
mercury (Hg). Please consult
your state and local
regulations regarding disposal
or recycling. Do not put it
in the trash.
caution
Do not touch the glass
portion of the lamp assembly.
Touching the glass could
result in premature lamp
failure.
portion of the lamp assembly.
Touching the glass could
result in premature lamp
failure.
note
Be sure to seat the lamp fully
and secure the lamp cover. If
the lamp is not properly
installed or the cover is loose,
the lamp will not turn on.
and secure the lamp cover. If
the lamp is not properly
installed or the cover is loose,
the lamp will not turn on.