Epson EB-G5650W User Manual
Warning
•
When replacing the lamp because they have stopped illuminating, there is a
possibility that the lamp may be broken. If replacing the lamp of a projector
which has been installed on the ceiling, you should always assume that the
lamp is broken, and you should stand to the side of the lamp cover, not
underneath it. Remove the lamp cover gently.
possibility that the lamp may be broken. If replacing the lamp of a projector
which has been installed on the ceiling, you should always assume that the
lamp is broken, and you should stand to the side of the lamp cover, not
underneath it. Remove the lamp cover gently.
•
Never disassemble or remodel the lamp. If a remodeled or reassembled lamp is
installed into the projector and used, it could cause a fire, electric shock, or an
accident.
installed into the projector and used, it could cause a fire, electric shock, or an
accident.
Caution
Wait until the lamp has cooled down sufficiently before removing the lamp cover.
If the lamp is still hot, burns or other injuries may result. It takes about one
hour after the power has been turned off for the lamp to be cool enough.
If the lamp is still hot, burns or other injuries may result. It takes about one
hour after the power has been turned off for the lamp to be cool enough.
Procedure
A
After you turn off the projector's power and the confirmation
buzzer beeps twice, disconnect the power cable.
buzzer beeps twice, disconnect the power cable.
B
Wait until the lamp has cooled down, then remove the
projector's lamp cover.
projector's lamp cover.
Loosen the lamp cover fixing screws with the screwdriver supplied
with the new lamp or a + head screwdriver, and then remove the
lamp cover. Because there is a string attached to the lamp cover to
prevent it from falling, it should never fall even when replacing the
lamp in a projector installed on the ceiling.
with the new lamp or a + head screwdriver, and then remove the
lamp cover. Because there is a string attached to the lamp cover to
prevent it from falling, it should never fall even when replacing the
lamp in a projector installed on the ceiling.
C
Loosen the two lamp fixing screws.
D
Take out the old lamp.
If the lamp is cracked, replace it with a new lamp, or contact your
local dealer for further advice.
local dealer for further advice.
s
Epson Projector Contact List
Replacing Consumables
105