Epson 10020 User Manual

Changing DIP Switches and Using Setup

This Appendix describes how to change the DIP switches on

the front panel of your computer and how to run the Setup

program on your Reference diskette. You may need this

information if you have changed the physical configuration of

your computer or you want to set the parameters for a serial

port.

The DIP switches on your computer are set to provide the

computer with information about its configuration. Each time
you turn on your computer, it checks the DIP switch settings to
verify the physical setup of your system.

The DIP switches are located underneath the cover on the

front panel, below the disk drives, as shown below:

These switches are set at the factory for 

particular

configuration. If you change anything, however—such as the

amount of memory, type of monitor, or number of parallel

ports-you may need to change a setting.

Changing DIP Switches and Using Setup

A-1