Edelbrock 63-0242 User Manual

©2004 Edelbrock Corporation
Rev. 1/04 - RS/mc

Catalog # 15002

Brochure # 63-0242

TURBOCHARGER FASTENER KIT

(For Turbocharger Kit #1500)

Catalog #15002

INSTALLATION INSTRUCTIONS

PLEASE study these instructions carefully before installing your new Edelbrock Turbocharger Fastener Kit.  If you have any
questions or problems, do not hesitate to contact our 

Technical Hotline at: 1-800-416-8628, from 7am-5pm, Monday-

Friday, Pacific Standard Time or via e-mail at:  

Edelbrock@Edelbrock.com.  Please fill out and mail your warranty card.

Installation Procedure

Kit Contents

Qty.

Description

❑

4

Stud, 8mm x 1.25 x 1.45” long

❑

5

Stud, 8mm x 1.25 x 1.75” long

❑

9

Nut, 8mm x 1.25

❑

9

Washer, 8mm

•

Description:  This fastener replacement kit contains all necessary hardware to mount the turbine inlet to the exhaust
manifold, and the outlet elbow to the turbine outlet.  The hardware is constructed of high-quality stainless steel and can
be used with any Garrett T25 or T28 Turbocharger.

Edelbrock Corporation

2700 California St.

Torrance, CA  90503

Tech Line:  1-800-416-8628

Office:  (310) 781-2222

E-Mail:  Edelbrock@Edelbrock.com

1. Hand tighten the 1.45”  long studs into the exhaust manifold, with the shorter threads towards the manifold 

(See Fig. 1).

2. Hand tighten the 1.75” long studs into the turbine outlet, with the longer threads towards the turbine outlet 

(See Fig. 2).

3. When attaching the turbocharger to the exhaust manifold, and the turbo outlet elbow to the turbocharger, use an 8mm

washer under each nut, and hand tighten the 8mm x 1.25 nuts onto the studs.

4. Torque the 8mm x 1.25 nuts to 190 inch/lbs. (approximately 16 ft/lbs).

Fig. 2

Fig. 1

Towards Exhaust

Elbow

Towards Turbine

Outlet

Towards Turbine

Inlet

Towards Exhaust

Manifold

1.75”

1.45”