Sun Microsystems enterprise server 220r User Manual
48
Sun Enterprise 220R Server Owner’s Guide • October 1999
Note –
If you have installed a PCI card as a second Ethernet interface, the operating
system asks you to select a primary network interface and then prompts you for its
host name and IP address. You must configure the second interface separately, after
the operating system is installed. See “How to Add an Ethernet Interface” on
page 49.
host name and IP address. You must configure the second interface separately, after
the operating system is installed. See “How to Add an Ethernet Interface” on
page 49.
Note –
This system conforms to the Ethernet 10/100BASE-TX standard, which
states that the Ethernet 10BASE-T link integrity test function should always be
enabled on both the host system and the Ethernet hub. If you have problems
verifying connection between this system and your hub, verify that the Ethernet hub
also has the link test function enabled. See “Network Communications Failure” onpage 147 and refer to the manual provided with your hub for more information
about the link integrity test function.
enabled on both the host system and the Ethernet hub. If you have problems
verifying connection between this system and your hub, verify that the Ethernet hub
also has the link test function enabled. See “Network Communications Failure” onpage 147 and refer to the manual provided with your hub for more information
about the link integrity test function.
What Next
After completing this procedure, the Ethernet harware interface is ready for
operation. However, in order for other network devices to communicate with the
system, your network administrator must enter the system’s IP address and host
name into the namespace on the network name server. For information about setting
up a network name service, consult the Solaris System Administrator AnswerBook for
your specific Solaris release.
operation. However, in order for other network devices to communicate with the
system, your network administrator must enter the system’s IP address and host
name into the namespace on the network name server. For information about setting
up a network name service, consult the Solaris System Administrator AnswerBook for
your specific Solaris release.
The
hme
Fast Ethernet device driver for the system’s standard Ethernet interface is
automatically installed with the Solaris release. For information about operating
characteristics and configuration parameters for the
characteristics and configuration parameters for the
hme
driver, see Platform Notes:
The hme Fast Ethernet Device Driver. This document is available on the Solaris on Sun
Hardware AnswerBook, which is provided on the Solaris Supplement CD for the Solaris
release you are running.
Hardware AnswerBook, which is provided on the Solaris Supplement CD for the Solaris
release you are running.
If you want to install and configure an additional network interface by means of a
PCI card, you must configure it separately, after installing the operating system; see:
PCI card, you must configure it separately, after installing the operating system; see:
■
“How to Add an Ethernet Interface” on page 49