Electrolux w4250n-s User Manual

87

6662

6663

Motor replacement

Disassembly

1.  Take down power from the machine.

2.  Remove the rear cover.

3.  Undo the bracket for the drain hose connec-

tor from the lower rear piece, then remove the
rear cover.

4.  Undo the ground connection from the motor.

5.  Remove the drive belt by pulling the belt

towards you while rotating the drum by hand.

6.  Undo the motor cable from motor.

7.  Lock the motor in place to avoid it from falling

when lifting it out.

8.  Undo and remove the two motor mounting

bolts.

9.  Lift out the motor.

10.  Replace the sensor and magnet from the old

motor into the new one.

Assembly

1.  Fit the new motor

 without locking the moun-

ting bolts.

2.  Fit the drive belt and adjust the belt tension

with the tensioner on one side of the motor.
Se section Adjustments - Drive belt tension
for details.

3.  Connect the new motor to the cable and use

straps to secure the cable.

4.  Connect the motor cable to the motor.

 

5.  Fit the lower rear piece and secure the drain 

hose connection with screws.

6.  Fit the upper rear piece.

7.  Connect the voltage supply and verify that the

motor operates normally.

Motor cable

Mounting bolt

Spacer

Motor cable