Electrolux u31216 ehg 7822 User Manual

10 electrolux

Hob burners control knobs

Hob burners control knobs

Hob burners control knobs

Hob burners control knobs

Hob burners control knobs

 The symbols on the knobs mean that :

 #

 there is no gas supply

 there is maximum gas supply

 there is minimum gas supply

Lighting the burners

Lighting the burners

Lighting the burners

Lighting the burners

Lighting the burners

For easier lighting, proceed before

For easier lighting, proceed before

For easier lighting, proceed before

For easier lighting, proceed before

For easier lighting, proceed before
putting a pan on the pan support.

putting a pan on the pan support.

putting a pan on the pan support.

putting a pan on the pan support.

putting a pan on the pan support.

To light a burner:

#

push in the relevant control knob and
turn it anticlockwise to maximum position
(

), to ignite the burner.

#

Upon ignition, keep the knob pushed
down about 5 seconds

 5 seconds

 5 seconds

 5 seconds

 5 seconds. This will allow

the "thermocouple" (Fig. 1 - letter D) to be
heated and the safety device to be
switched off, otherwise  the gas supply
would be interrupted.

#

Then adjust the flame as required.

If the burner does not ignite, turn the
control knob to zero, and try again.

When switching on the mains, after
installation or a power cut, it is quite
normal for the spark generator to be
activated automatically.

In the absence of electricity, ignition can
occur without the electrical device; in this
case, approach the burner with a flame,
push the relevant knob down and turn it
anti-clockwise until it reaches the
“maximum” position.

If the control knobs become difficult to turn, please contact your
local Service Force Centre.

!

A - Burner cap
B - Burner crown
C - Ignition electrode
D - Thermocouple (only in
model EHG 7822)