Adtran MX2800 M13 User Manual
MX2800 M13 Multiplexer User Manual
Acceptance Test Procedure, Appendix A
61200290L1-1G
A-9
Single Power Supply Module / Dual Power Feeds
When the MX2800 is equipped with only a single Power Supply module, there is no protection against a
failure of the module itself. However, the single Power Supply is capable of utilizing the
failure of the module itself. However, the single Power Supply is capable of utilizing the
A
and
B
power
feeds to protect against a failure in one of the power sources feeding the shelf. To verify that the MX2800
is properly utilizing the
is properly utilizing the
A
and
B
power feeds, the following procedure is recommended:
1. With the MX2800 installed and operating normally, go to the fuse panel at the top of the bay and
remove the fuse corresponding to the
A
power feed for the MX2800 shelf. Removing this fuse should
have no effect on the operation of the shelf because the MX2800 is operating on the
B
power feed.
2. Reinsert the fuse for the
A
power feed.
3. Now, remove the
B
power feed fuse for the MX2800 shelf. Once again, there should be no effect on
the operation of the shelf because the MX2800 is operating on the
A
power feed.
4. Reinsert the fuse for the
B
power feed.
Dual Power Supply Modules / Dual Power Feeds
When the MX2800 is equipped with two Power Supply modules and also wired to support dual power
feeds, the shelf is protected against a failure of either of the Power Supply cards or a failure of one of the
power sources feeding the shelf. Use the following procedure to confirm the operation of this fully redun-
dant configuration:
feeds, the shelf is protected against a failure of either of the Power Supply cards or a failure of one of the
power sources feeding the shelf. Use the following procedure to confirm the operation of this fully redun-
dant configuration:
1. With the MX2800 installed and operating normally, remove the
A
Power Supply card (the one on the
left). Removing this card should have no effect on the operation of the shelf because the MX2800 is
operating on the
operating on the
B
Power Supply.
2. Go to the fuse panel at the top of the bay and remove the fuse corresponding to the
A
power feed.
Removing this fuse should have no effect on the operation of the shelf because the
B
Power Supply is
running on the
B
power feed.
3. Reinsert the fuse for the
A
power feed.
4. Remove the fuse corresponding to the
B
power feed to the shelf. Doing so should have no effect on the
operation of the shelf as the
B
Power Supply is operating on the
A
power feed.
5. Reinsert the fuse for the
B
power feed.
6. Reinsert the
A
Power Supply into the MX2800 chassis.
7. Remove the
B
Power Supply card (the one on the right). Doing so should have no effect on the
operation of the shelf because the MX2800 is operating on the
A
Power Supply.
8. Go to the fuse panel at the top of the bay and remove the fuse corresponding to the
A
power feed.
Removing this fuse should have no effect on the operation of the shelf because the
A
Power Supply is
now running on the
B
power feed.
9. Reinsert the fuse for the
A
power feed.
10. Remove the fuse corresponding to the
B
power feed to the shelf. Removing this fuse should have no
effect on the operation of the shelf as the
A
Power Supply is operating on the
A
power feed.
11. Reinsert the fuse for the
B
power feed.
12. Reinsert the
B
Power Supply into the MX2800 chassis.