AGFA ePhoto CL18 User Manual

NOTES:
• If using the Network interface cable, be sure to connect 

the printer with a network interface cable and to turn it on.

• If using the Parallel or USB interface cable, be sure to turn 

off the printer or not to connect the printer with an interface 
cable to avoid the Plug and Play installation.

■ For Windows

There are the following two methods to install the printer 
driver for Windows.

• Automated Driver Installation
• Custom Driver Installation

This Setup Guide only briefly explains Automated Driver 
Installation. For detailed instructions, refer to the 
Installation section.

NOTE:
• For Windows NT 4.0, Windows 2000, Windows XP and 

Windows Server 2003, make sure to log on as an 
administrator.

Insert the printer CD-ROM into the CD-ROM drive.
The CD-ROM launches automatically.

NOTE:
• If the CD-ROM does not launch automatically, 

perform the following steps (1) - (2).
(1) Double-click the My computer icon.

(Windows XP / Windows Server 2003: Start - 
My Computer)

(2) Double-click the CD-ROM icon.

Click Install Printer Driver.

Click Automated Driver Installation.
The License Agreement window is displayed.

Click [Yes].
The Printer port selection window is displayed.

[A] When using the Network interface cable:
Click on Select the Network port for DP-CL18 
check button, and select the printer of the IP Address 
confirmed on the Configuration Page (refer to 
“Printing the Configuration Page” on page 17).

[B] When using the Parallel interface cable:
Click on Select an existing printer port check 
button, and click on the LPT port (Example: LPT1).

[C] When using the USB interface cable:
Click on Install via the USB port (plug and play 
installation) check button.

Click [Next>].
The Installed Options window is displayed.

Click on the check box of the installed options in your 
printer and select the total memory from the Memory 
list, and click [Next >].
The setup program starts installing the printer driver.

[A] When using the Network interface cable: 
(1) Click [Finish].

[B] When using the Parallel interface cable: 
(1) Click [Finish] and turn the printer on.

If the Welcome to the Found New Hardware 
Wizard window is displayed, refer to the 
Installation section.

[C] When using the USB interface cable: 

NOTE:
• For Windows 98, only Windows 98 SE is available 

when using a USB interface.

(1) When the Connect the printer to the computer 

window is displayed, connect the USB interface 
cable and turn the printer on.

Perform the following steps depending on the 
operating system:
For Windows 98 / Windows Me:
(2) When the InstallShield Wizard Complete 

window is displayed, click [Finish].

For Windows 2000:
(2) If the Digital Signature Not Found window is 

displayed, click [Yes].
The InstallShield Wizard Complete window is 
displayed.

(3) Click [Finish].
For Windows XP / Windows Server 2003:
(2) If the Welcome to the Found New Hardware 

Wizard window is displayed, refer to the 
Installation section.

(3) Click [Finish].

NOTE:
• Restarting of the computer may be required 

depending on your computer environment. In this 
case, restart your computer.

■ For Windows (with Upgrade Kit)

When installing the printer driver for the printer equipped 
with the Upgrade Kit, use the printer CD-ROM provided 
with the Upgrade Kit.

The Automated Driver Installation is the same with the 
above steps. For detailed instructions, refer to the 
Installation section.