Teka hw70-1201s User Manual
06
Before use
3.
1.
2.
4.
DISMANTLE ThE TRANSPORTATION BOLTS
The transportation bolts are designed for clamping anti-vibration components
inside of the washing machine during the transportation process.
inside of the washing machine during the transportation process.
Remove the back cover.
1.
Remove the four bolts on the rear side and take out the synthetic
2.
stabilisers from within the machine.
stabilisers from within the machine.
Replace the back cover.
3.
Fill the holes left by the bolts with blanking plugs.
4.
Note:
1.when you replace the back cover,the convexity must face
to outside, and you have to insert the back cover from the
two gaps as shown in fig.5.
2.keep the transportation bolts and synthetic stabilisers
in a safe place for later use.
1.when you replace the back cover,the convexity must face
to outside, and you have to insert the back cover from the
two gaps as shown in fig.5.
2.keep the transportation bolts and synthetic stabilisers
in a safe place for later use.
ADjUSTINg ThE wAShINg MAChINE
There are adjustable feet under the bottom of the washing machine. Before use, they should be
adjusted so that the machine is level. This will minimise vibrations and thus noise during use. It will also
reduce wear and tear. We recommend using a spirit level to level the appliance.The floor should be as
stable and flat as possible.
adjusted so that the machine is level. This will minimise vibrations and thus noise during use. It will also
reduce wear and tear. We recommend using a spirit level to level the appliance.The floor should be as
stable and flat as possible.
instAllAtion
5.