Epson equity 320sx plus User Manual

There are two ways to reset the computer:

If you are using MS-DOS, hold down 

and 

and

press the 

key. The screen goes blank for a moment

and then the computer should reload MS-DOS. If it

doesn’t, try the next method.

the 

button on the front panel. This method

works even when the computer does not respond to your

keyboard entries.

If resetting the computer does not correct the problem, you
probably need to turn it off and reboot it. Remove any
diskette(s) from the diskette drive(s). Turn off the computer

and wait five seconds. If you do not have a hard disk, insert

the Startup diskette in drive A. Then turn on the computer.

If you set a password when you ran the SETUP program, you
must enter it every time you turn on the computer or press
the 

button. Follow these steps to use your password:

1.

If you do not have a hard disk, insert your Startup

diskette in drive A.

2. Turn on the computer or press 

After the computer

completes its memory test, the screen displays the
following prompt:

3. Type your password at the prompt. The screen does not

display the characters you 

Then press 

After you type the password correctly and press 

the 

prompt. If you do not

press 

the computer loads MS-DOS and displays the

MS-DOS command prompt.