Seventeam ST-400P-AD Leaflet

ST-400P-AD

Ver. 1.0

u INPUT CHARACTERISTICS:

§ VOLTAGE: 100VAC ~ 240

VAC

§ FREQUENCY: 50

~60

§ INPUT CURRENT:

7~4

A (RMS)

§ INRUSH CURRENT: 80A for 230VAC / 60A for 115VAC.

u SPECIFICATION:

§  EFFICIENCY: 78% MAXIMUM, FULL LOAD CONDITION AT 115/230 VAC INPUT.
§  POWER GOOD SIGNAL: ON DELAY TIME 100 ~ 500 ms, OFF DELAY TIME 1ms.
§  HOLD UP TIME: 16 ms AT 25℃  80% LOAD CONDITION AT 115-230 VAC INPUT.
§  OPERATING TEMPERATURE RANGE: 5℃  ~ 50℃.
§  REMOTE  ON/OFF  CONTROL:  THE  POWER  SUPPLY  OUTPUT  SHALL  BE  ENABLED  WITH  AN

ACTIVE-LOW TTL SIGNAL. WHEN TTL SIGNAL IS LOW, THE DC OUTPUTS ARE TO BE ENABLED.
WHEN TTL SIGNAL IS HIGH OR OPEN CIRCUITED, THE DC OUTPUTS ARE TO BE DISABLED.

§ OVER POWER PROTECTION: AT 115/230 VAC INPUT THE POWER SUPPLY WILL SHUT DOWN

ALL DC OUTPUT WITH IN 110% TO 150% OF FULL LOAD.

§  OVER VOLTAGE PROTECTION: +5V  →  6.5V, +12V  →  15.5V, +3.3V  →  4.6V.
§  EMI REQUIREMENT: FCC PART 15 SUBPART B, CLASS B AT SYSTEM LOAD, CISPR 22 CLASS B.
§  SAFETY: TUV, UL, CE, CB, FCC, BSMI
§  DIMENSION: 140 (D) x 150 (W) x 86 (H) mm.
§  COOLING: ONE 80 mm DC FAN.
§  ACTIVE POWER FACTOR CORRECTION: EN 61000-3-2: 1995+A1+A2: 1998, CLASS D.

u OUTPUT CHARACTERISTICS:

OUTPUT CURRENT

REGULATION

OUTPUT

VOLTAGE

MIN

[A]

MAX

[A]

LOAD

LINE

RIPPLE

MAX

[P-P]

NOISE

MAX

[P-P]

+12V1

2.0

±5%

±1%

120mV

+12V2

2.0

±5%

±1%

120mV

+5V

2.0

±5%

±1%

50mV

+3.3V

2.0

±5%

±1%

50mV

-12V

0.8

±10%

±1%

120mV

-5V

0.3

±10%

±1%

100mV

+5VSB

0.1

2.5

±5%

±1%

50mV

1. MAXIMUM CONTINUOUS COMBINED LOAD ON +5V AND +3.3V OUTPUTS SHALL NOT EXCEED 150W.

2. MAXIMUM CONTINUOUS COMBINED LOAD ON +12V1, +12V2, OUTPUTS SHALL NOT EXCEED

360 W(30A).

3. MAXIMUM CONTINUOUS TOTAL DC OUTPUT POWER SHALL NOT EXCEED 400W.

PDF created with pdfFactory trial version