Pitney Bowes DM1000 User Manual

• Do not connect your postage meter (Postal Security Device) to a digital 

phone line. The device’s built-in modem is designed to work with an 

analog phone line only. (Your fax machine is usually connected to an 

analog phone line.) If you do not know if your line is digital, call your 

phone provider for verification.

• Disconnect the telephone cord from the wall before removing the 

IntelliLink® Control Center.

• Use only Pitney Bowes approved supplies, in particular aerosol dusters. 

Improper storage and use of aerosol dusters or flammable aerosol dust-

ers, can cause an explosive-like condition that could result in a personal 

injury and/or property damage. Never use aerosol dusters labeled flam-

mable and always read instructions and safety precautions on the 

duster container label. 

• To obtain Pitney Bowes supplies, please contact our Pitney Bowes Sup-

ply Line™. Material Safety Data Sheets can be obtained on the web or 

from our Pitney Bowes Supply Line™. Refer to the Pitney Bowes Con-
tact Information List

 at the front of this guide for phone numbers and 

web site information.

• Use the power cord supplied with the machine and plug it into a properly 

grounded wall outlet located near the machine and easily accessible. 

Failure to properly ground the machine can result in severe personal 

injury and/or fire.

• Avoid touching moving parts or materials while the machine is in use. 

Keep hands, loose clothing, jewelry and long hair away from all moving 

parts.

• Do not remove covers. Covers enclose hazardous parts that should only 

be accessed by properly trained service personnel. Immediately report 

to Pitney Bowes Service any damaged or non-functioning components 

that renders the unit unsafe.

• Place the unit in an accessible location to allow for proper venting of the 

equipment and to facilitate servicing. 

• The power cord wall plug is the primary means of disconnecting the 

machine from the AC supply. 

• Do not use an adapter plug on the line cord or wall outlet.

• Do not remove the ground pin from the line cord.

• Avoid using wall outlets that are controlled by wall switches, or shared 

with other equipment.

• Do not route the power cord over sharp edges or trapped between furni-

ture.

• Ensure there is no strain on the power cord where it becomes jammed 

between the equipment, walls or furniture.

To reduce the risk of fire, use only the 26 AWG 

telecommunication line cord supplied separately. 

 Follow normal safety precautions for all office equip-

ment whenever using the Power Stacker.